Thingiverse
iPad Wall Holder Bat
von m-heim
0
Downloads
0
Likes
0
Makes
An iPad holder i made for our kitchen. For use with 3/3.5 mm countersunk screws
My iPad has a case so it might be loose or doesnt fit, depending on the dimensions of your tablet. On request i might add other thicknesses
Measurements used for slot: 285 x 195 x 19.4 mm
It is recommended to print the 2 parts flat, this way only the corners need supports (which will go through the bats)
Licence: CC BY-NC
My iPad has a case so it might be loose or doesnt fit, depending on the dimensions of your tablet. On request i might add other thicknesses
Measurements used for slot: 285 x 195 x 19.4 mm
It is recommended to print the 2 parts flat, this way only the corners need supports (which will go through the bats)
Licence: CC BY-NC
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
