Thingiverse
IPASS BRACKET
by kmccon
14
Downloads
10
Likes
0
Makes
Bracket to suction cup a toll road transponder to your windshield. Our transponder came with the Velcro pre-attached so I decided to design a bracket to work with that and a suction cup.
Included are .step files of the holder, transponder and suction cup.
The suction cup came with our old transponder holder. It is approximately 42 mm (1.6) in diameter.
UPDATE: I printed my first one out of PLA. I just noticed today that it has warped and needs to be replaced. My guess is it got a little hot...
Will either reprint in ABS or High Temp PLA. May also look into adding some more structure.
Included are .step files of the holder, transponder and suction cup.
The suction cup came with our old transponder holder. It is approximately 42 mm (1.6) in diameter.
UPDATE: I printed my first one out of PLA. I just noticed today that it has warped and needs to be replaced. My guess is it got a little hot...
Will either reprint in ABS or High Temp PLA. May also look into adding some more structure.
kmccon also publishes on
34 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!