iPhone 14 Pro Case and Stand

Print the case in TPU. I do not use support but you will likely need to trim some of the TPU that did not bond on a few overhangs.

Print the cameraAssyCase part and use superglue or PVC glue to bond it to the back of the case.

Notice the small lip on the top of the cameraAssyCase. This is to assist with alignment when glueing to the case.

Print the iphone14Stand using PLA or PETG. It will hold an official Apple MagSafe charger. I used the 7% lightning infill when printing. This allowed me to then drill a hole on the bottom of the iphone14Stand and filled it with Plaster-of-Paris to give it more weight.

If the MagSafe slips out, put a little bit of Kapton tape (or similar) around the edge of the charger before inserting into the stand to tighten it up.

I added a minimalistic stand that will allow free rotation of the iPhone.