Slicer Discord
Iphone 6 Car Mount – 3D printable model from Thingiverse Thingiverse

Iphone 6 Car Mount

19 Downloads
5 Likes
0 Makes
Go to Model
I made this iphone mount to hold my phone in either the vertical position while playing music in my car, or in the horizontal position to act as my gps. recently I had been having to make many trips up to 7 hours away and I was using my phone as a gps so often it became dangerous to try to hold it and drive this little gadget is great and works great with the slimmer otter box cases. but it can (could) be used without a case on the phone. I uploaded a few different versions of the case. my printer only prints in PLA plastic so when i left my first version of this mount in the car on a hot day in florida it melted to the shape of my dash board. then i tried to make a few different versions to increase strength and stability. whichever version of the sidewalls you decide to use, i affixed the walls with superglue or 5-minute epoxy and the vent hook and its slider component must be attached with glue/epoxy. the slider which makes this mount so easy to turn orientation also makes it great
Source
Thingiverse
What you need to print this: Intermediate Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA
Est. print time
7 h
Post-processing
Gluing
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection