Thingiverse
iPhone 6 stand
por Lukuky64
8
Descargas
3
Likes
0
Makes
This is designed for an iPhone 6 using 123D design. The design took me roughly one hour to print with 30% density and 0.2mm layer height which used up around 4.5 metres of ABS plastic. I use this on my desk when I am on my computer so I am able to easily read notifications without picking up my device.
Suggestions:
- Coat plastic in epoxy glue for a shiny look and extra strength, make sure to let it dry or your phone may stick to the stand
- Use raft to prevent plastic bending when being printed
- Use glue when assembling the rods
- Use acetone on the rods to remove thin layers of plastic if it doesn't fit in the holes
Suggestions:
- Coat plastic in epoxy glue for a shiny look and extra strength, make sure to let it dry or your phone may stick to the stand
- Use raft to prevent plastic bending when being printed
- Use glue when assembling the rods
- Use acetone on the rods to remove thin layers of plastic if it doesn't fit in the holes
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
