Gadgets
Zum Modell
iPhone 7 dock with Slim leather case
314
Downloads
273
Likes
11
Makes
iPhone 7 charging dock and stand. Has ports so sound out of the speaker is somewhat amplified and directed forward. Was inspired by some other docks I have seen around but ended up designing it from scratch to accommodate my case, which is a slim leather case.
the slot size is 72 mm x 10 mm ended up about 71.5mm x 9.5 mm after printing and there is still some room for a slightly bigger case than mine but it still holds the phone snuggly.
Pretty easy to route the cable through just push it up through the large slot on the left of the dock and the slide the cable across and pull downed then continue to press the cable it to the gap which will keep the cable in once its pushed all the way in.
**Note must use original iPhone cable**
the slot size is 72 mm x 10 mm ended up about 71.5mm x 9.5 mm after printing and there is still some room for a slightly bigger case than mine but it still holds the phone snuggly.
Pretty easy to route the cable through just push it up through the large slot on the left of the dock and the slide the cable across and pull downed then continue to press the cable it to the gap which will keep the cable in once its pushed all the way in.
**Note must use original iPhone cable**
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!