Thingiverse
iphone 7 dragon case
von fire_at7300
12
Downloads
11
Likes
0
Makes
When you put the phone in the case the speaker brake at the bottom might come off. this case was originally meant for a flexible filament but if you use plastic like i did then the brace for the speaker grill will most likely come off. This is a work in progress so i will be updating some files to see what works best. I wanted to make a new phone case since mine is starting to fall apart so i found a Iphone 7 bumper case and used the extrude and subtract tool in 3D builder to punch a whole in the back. I've always had interest in dragons and if you do to then here you go.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
