iPhone 7 Eyepiece Adapter

New and improved! I call this v2.3, which is the next higher number, I guess. Improvements in the configuration of the eyepiece holder and a bit more re-inforcement on the support structure. Print this at about 50% fill to reduce the weight a bit.

This is my re-mix of Robert-G's very nice adapter. I offset the eyepiece holder to work on iPhones that have the camera lens in the upper corner rather than centered on the back of the phone.
I did make the switch to 1/4 by 20 SAE hardware. It is a good replacement for the metric hardware of the original. 6mm and 1/4' are nearly the same anyway.

needed: (4 of each) 1/4 x 20 1 1/2" hex head bolt
1/4 x 20 hex nut
1/4 x 20 wing nut

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/hyBKfL9Ohsd