Thingiverse
iPhone 7 in case holder
by Merleatron
2
Downloads
0
Likes
0
Makes
Made for holding an iPhone 7 on a refrigerator. 12 insets on the back for .25 inch magnets.
Edit: Went back through to get the internal area so it would be easier to see if would be useful
H: 100mm
W: 72.5mm
D: 15mm
Bottom lip height: 4mm
Side bezel: 3mm
Edit: Went back through to get the internal area so it would be easier to see if would be useful
H: 100mm
W: 72.5mm
D: 15mm
Bottom lip height: 4mm
Side bezel: 3mm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
