iPhone Charger Mount

Just a simple remix of iPhone Charging Dock by OgreMills
I liked the design, except I didn't want the charger cover to extend beyond the actual charger, so I edited the STL file in 3D Builder (Windows 10).

My print had a slight line on the left side of the charging cover for some reason, perhaps it's just a quirk of my printer and this particular print, but it's easily fixable with a little sanding. Not worth re-printing because of it. Not sure if it's in the STL or just the print, so it might be worth checking into if you're going to print this file.

If I was to redesign this again, I would probably add a little clip to hold the end of the charging cable and put some sort of flat edges along the sides and bottom of the hole that holds the charger, because the charger itself isn't strong enough to hold the weight if you have even slightly loose electrical sockets. I'd actually skip the charger holder all together and just make it an Electrical Wall Plate w/ Phone Holder on top.