Thingiverse
IPHONE SE CASE
door johnroy22222
1
Downloads
2
Likes
0
Makes
This is a slightly modified design from the original JRCOHEN4
https://www.thingiverse.com/thing:4309572
Basically i ve added 2 slits (i stole the idea from the case i ordered) on the bottom so i could "easily" slide in my iphone in it (i printed it with PLA...probably not a good idea...)
First attempt turned out to be too fragile..
V3 has smaller slits, it seems sturdier but harder to slide phone in it.
Next improvement : more holes for heat dissipation when phone is charging...
Other improvement : add piece of plastic to push buttons easily
Printed with flsun delta printer.
https://www.thingiverse.com/thing:4309572
Basically i ve added 2 slits (i stole the idea from the case i ordered) on the bottom so i could "easily" slide in my iphone in it (i printed it with PLA...probably not a good idea...)
First attempt turned out to be too fragile..
V3 has smaller slits, it seems sturdier but harder to slide phone in it.
Next improvement : more holes for heat dissipation when phone is charging...
Other improvement : add piece of plastic to push buttons easily
Printed with flsun delta printer.
johnroy22222 publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
