iPod Classic Generation 4 Stand

The iPod Classic Generation 4 Stand is based off the DN-40 series clock design by Dieter Rams. I initially printed this in red Elegoo PLA to match the soft iconic red seen on the DN-40 timepieces. The stand keeps the iPod at a fixed 60 degree angle, and comfortably seats the iPod while doing so, not scratching the device yet keeping a fine grasp. No supports are needed to print the model.

iPod in this photo:
- 20gb
- iPod Classic Generation 4
- Contains a Raspberry Pi 0 W

If you want to follow the project's progress, check out the iPodPi project at https://github.com/john-robotic/iPodPi