Thingiverse
IR_POD
von 3bprints
2
Downloads
5
Likes
0
Makes
This custom designed "IR_POD" is meant to hold 2 infrared LEDs and 1 infrared detector snugly as to ease the testing and later prototyping of a project im currently working on.
The 2 round holes can hold most common sized LEDs and the rectangle in the middle is for holding a TSOP IR detector.
The dimensions allow the IR LEDs light rays to be focused foward and outward and allows the IR detector to be sheilded from any outside rays of light. However the pod can be used for many other small projects involving any type of LEDs.
INSTALLATION :
The front of the pod is identified by having a completly flat surface.
The back of the pod is identified by having small chamfers(indents) of about 0.2mm for the LEDs and 0.2mm-0.3mm for the detector which is also recessed a bit.
Insert LEDs top first from the back and the detector face first from the back of the pod.(you may need to remove metal case that most TSOP IR detectors have)
You may want to use a small amo
The 2 round holes can hold most common sized LEDs and the rectangle in the middle is for holding a TSOP IR detector.
The dimensions allow the IR LEDs light rays to be focused foward and outward and allows the IR detector to be sheilded from any outside rays of light. However the pod can be used for many other small projects involving any type of LEDs.
INSTALLATION :
The front of the pod is identified by having a completly flat surface.
The back of the pod is identified by having small chamfers(indents) of about 0.2mm for the LEDs and 0.2mm-0.3mm for the detector which is also recessed a bit.
Insert LEDs top first from the back and the detector face first from the back of the pod.(you may need to remove metal case that most TSOP IR detectors have)
You may want to use a small amo
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
