Slicer Discord
Ironing Recommended Settings Calibration Test – 3D printable model from MakerWorld MakerWorld
Test Models

Ironing Recommended Settings Calibration Test

6.1k Downloads
2k Likes
3.4k Makes
Go to Model
Recommended Ironing Settings – Tested and ComparedThis file contains a side-by-side comparison of 9 different ironing configurations for top surfaces in 3D printing. Perfect if you're looking to improve the surface quality of your prints and want to skip hours of trial and error, i have made a collection of the most popular version that i have found. πŸ” The settings vary in:Ironing Speed (from 25 mm/s to 150 mm/s)Flow Rate (percentage of material extruded)Top Surface SpeedWith and without ironingUPDATE: Debossed numbering on the bottom (first number = ironing speed, second number = ironing flow)πŸ“Œ The 60 mm/s & 30% flow version is the same one I shared on Reddit, you can see my posts here: https://www.reddit.com/r/3Dprinting/comments/1mets65/perfect_ironing_results_every_single_time/ https://www.reddit.com/r/3Dprinting/comments/1mfz2cu/here_we_go_again_perfect_ironing_results_every/ This is the exact file I use when comparing ironing results between filament types or tuning for spe
Category
Test Models
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord β˜• Buy me a coffee
DE EN FR ES IT NL

Add to Collection