Thingiverse
Itachi BookMark
1
Downloads
1
Likes
0
Makes
This model was my early work so the model is Thick
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 112.11x200mm in size
You may print at higher layer heights below the Base Thickness of 1.52mm
The Max allowed Thickness is 3.28mm and the Actual Thickness is 3.28mm
Swap Instructions:
Start with Black
At layer #21 (1.76mm) swap to White
At layer #31 (2.56mm) swap to Red for the rest.
Setting
Layer height: 0.08
Initial Layer height: 0.16
Wall: 2
Sparse infill density: 100%
Sparse infill pattern: Rectilinear
Turn Off Prime Tower
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 112.11x200mm in size
You may print at higher layer heights below the Base Thickness of 1.52mm
The Max allowed Thickness is 3.28mm and the Actual Thickness is 3.28mm
Swap Instructions:
Start with Black
At layer #21 (1.76mm) swap to White
At layer #31 (2.56mm) swap to Red for the rest.
Setting
Layer height: 0.08
Initial Layer height: 0.16
Wall: 2
Sparse infill density: 100%
Sparse infill pattern: Rectilinear
Turn Off Prime Tower
vividprintwork also publishes on
27 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
