Thingiverse
ITX Case without Hardware Limits
von markusz2n
11
Downloads
8
Likes
0
Makes
Wanted an ITX Case that can fit my RTX 2070 with a Morpheus cooler and full-size fans, so I designed it myself!
Supports big hardware, uses ATX Power Supplies (140mm length is recommended)
Space for 2x 2,5" SDD/HDD using the SSDMount, but Graphics card length will be limited to 346 mm
Graphics card bracket can only be 1 or 2 slots high.
For the PCIe Riser, I used a Kolink 30cm PCIe Riser.
Step Models are included if you want to change the design a bit or add support for sfx-PSU's or another riser cable.
You may need a low profile 90° connector for the PSU power.
The Power and Reset button are Cherry MX Green Switches and for Power and HDD LED I used 3mm LED's.
Supports big hardware, uses ATX Power Supplies (140mm length is recommended)
Space for 2x 2,5" SDD/HDD using the SSDMount, but Graphics card length will be limited to 346 mm
Graphics card bracket can only be 1 or 2 slots high.
For the PCIe Riser, I used a Kolink 30cm PCIe Riser.
Step Models are included if you want to change the design a bit or add support for sfx-PSU's or another riser cable.
You may need a low profile 90° connector for the PSU power.
The Power and Reset button are Cherry MX Green Switches and for Power and HDD LED I used 3mm LED's.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
