Izzet Keyrune

Welcome to the world of discovery and science with the Izzet Guild!

I left out the wires seen on the original card as modeling them would be way too difficult and most likely wouldn't print very well. That being said, I did place slots in some of the pieces jutting out of the sides that you make take some cable yourself and place them onto the key.

Approximately 9" from tip to tip. There are files for the complete model as well as the separate pieces (if, like me, your printer doesn't print very big. :P)

I hope you enjoy!

Printer Settings:
Elegoo Mars:
Settings using Translucent Standard Photopolymer Resin (Elegoo)

Layer Height 0.04
Bottom Layer Count: 7
Bottom Exposure Time: 75s

Bottom Lift Distance: 4mm
Lifting Distance: 4mm
Bottom Lift Speed: 20mm/min
Lifting Speed: 40mm/min
Retract Speed: 150 mm/min

Infill: None.