Thingiverse
Izzy Swan's Hold down clamp
von Cardwelc
213
Downloads
111
Likes
0
Makes
This is a model of Izzy Swan's DIY hold down clamp. Here is a link to Izzy's website and his free plans: http://www.izzyswan.com/product/toggle-hold-down-clamps-free-plans/
I haven't printed these yet. There are two models; one that uses 3/4" wide pieces, and another that I scaled down to fit on my printer (the longest piece is 6").
THE STL FILES ARE ALL FROM THE SMALL MODEL.
The holes are 1/4" dia on the regular model. The holes on the smaller model would need to be reamed to size or remodeled. The small model has all the pieces broken out and ready to export for printing. Also, neither of the files include a base to affix the whole thing to, nor pre-modeled holes to fix each piece to the other (i.e. the front two rectangular pieces would need to be screwed or bolted to the clamping arm, etc).
I am not confident a 3d printed model of these will be strong enough for serious clamping. Light duty, they should do fine. But, if you were going to make a lot of these
I haven't printed these yet. There are two models; one that uses 3/4" wide pieces, and another that I scaled down to fit on my printer (the longest piece is 6").
THE STL FILES ARE ALL FROM THE SMALL MODEL.
The holes are 1/4" dia on the regular model. The holes on the smaller model would need to be reamed to size or remodeled. The small model has all the pieces broken out and ready to export for printing. Also, neither of the files include a base to affix the whole thing to, nor pre-modeled holes to fix each piece to the other (i.e. the front two rectangular pieces would need to be screwed or bolted to the clamping arm, etc).
I am not confident a 3d printed model of these will be strong enough for serious clamping. Light duty, they should do fine. But, if you were going to make a lot of these
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!