Thingiverse
J-Channel LED Tool
door ddubau
12
Downloads
4
Likes
0
Makes
This is a template/jig to help speed up the process of drilling holes in J-Channel for mounting RGB LED lights to your house or other things.
The holes are made to support a 1/2 drill bit which works well with the bullet type lights.
The holes are spaced 4 inches apart.
You use this by drilling one starting hole and then flipping the device upside down and putting the starting pin inside of the first hole. This will then allow you to hold the tool perfectly even with the J-Channel as its the same width. You can then drill holes where the tool holes land and then move the tool to continue down the length of your J-Chanel.
The holes are made to support a 1/2 drill bit which works well with the bullet type lights.
The holes are spaced 4 inches apart.
You use this by drilling one starting hole and then flipping the device upside down and putting the starting pin inside of the first hole. This will then allow you to hold the tool perfectly even with the J-Channel as its the same width. You can then drill holes where the tool holes land and then move the tool to continue down the length of your J-Chanel.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!