Jack In The Box Earrings

This project is for a set of Jack In The Box earrings. To preserve the detail of the model it must be printed with a 0.2mm nozzle using a 0.1mm layer height. Printing on a smooth build plate will produce a very nice result, though a textured plate could be used if you prefer. If the first layer isn't sticking to the build plate, try cleaning the plate and/or smearing on a little glue stick before printing. Each earring is printed in two halves with the finished surface on the build plate. The halves will need to be glued together. I recommend aligning the two halves and then clamping one side with a binder clip or other small clamp. Then spread the halves slightly and use a straight pin to put a couple drops of super glue between the halves before clamping the other half with another binder clip. Wait for a few minutes and then repeat the process for the other side.