Slicer Discord
Jack-O-Lantern Light Box – 3D-printbaar model van MakerWorld MakerWorld
Decor

Jack-O-Lantern Light Box

door Hot Potato · Decor
1 Downloads
3 Likes
0 Makes
Model downloaden
A fun light up Halloween Jack-O-Lantern I used a cheap dollar store LED strip around the inside of the outside shell. The remote works through the thin front so that makes it easy. There are two small parts that are completely optional. They are used to plug the hole on the back once you pass the USB plug through for the light. I did this to keep things clean looking but they really aren't needed. I lined the back with aluminum tape to give it a bit of a reflective surface but again that's not really needed. Because I wanted as much light to show through as possible the white (light part) is only 2 layer thick. Be careful when handling it Mine was intended to be Orange all the way around with a white and orange face but I had less orange than I thought (doh!) Boost MeEvery boost encourages me to upload more of my designs and to create more
Categorie
Decor
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie