Thingiverse
Jacot Lathe Base
1
Downloads
2
Likes
0
Makes
This base fits a Steiner made Jocot Lathe made to polish pivots.
The groove is approximately 6mm wide and has a slight taper to snuggly fit to the base.
I printed mine at 25% infill with no support material was PLA
No finishing needed, maybe file to fit your specific base
The groove is approximately 6mm wide and has a slight taper to snuggly fit to the base.
I printed mine at 25% infill with no support material was PLA
No finishing needed, maybe file to fit your specific base
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!