Slicer Discord
Jaded: An old-fashioned pixelated easter egg – Modelo 3D imprimible de MakerWorld MakerWorld
Festivities

Jaded: An old-fashioned pixelated easter egg

14 Descargas
12 Likes
3 Makes
Ver Modelo
After designing a trick easter egg (see remix link below), I decided to make a version that's simpler to open. In order to get this to look nice, I had to figure out a way to lock the two halves together nicely but reversibly. As it turns out, this is a little harder than it looks…. especially with typical FDM tolerances. After a good deal of testing, I settled on an insert model that requires a little super glue, but works quite well with a little squeeze of the egg. I hope this is a useful result for people to make good looking Easter eggs from! Printing Notes This is probably obvious: print the two egg halves with widest parts shells facing down. Use supports (organic/tree preferably) to support the inside domes of the egg halves. If you can get away without brims for the main parts, the result will be better. I was able to print fine without brims on everything but the little pins. I printed in cloudy white PETG at 0.16 mm layer height with 3 walls at 10% infill. A small layer heig
Categoría
Festivities
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
¿Por qué?
capas de 0.16mm
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PETG
Altura de capa
0.16 mm
Postprocesado
Pegado
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

Adam L también publica en

241 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

1 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección