Thingiverse
Jankstax One
door Photochemicals
6
Downloads
14
Likes
0
Makes
This is a (mostly) 3d printed Instax camera, with printed diaphragm and shutter. The non-printed parts needed are:
- Jollylook Instant Mini Film Development Unit (https://jollylook.com/products/jollylook-instax-mini-film-development-unit)
- 1 - 100mm focal length, 40mm Diameter, 6mm height lens (https://www.amazon.com/dp/B0C3B8DSBX)
- 4 - M3 x 30 screws, 1 - M3 x 8 screws, 2 - M2 x 20 screws, and 2 - M2 x 8 screws
- 1 - 120 degree, 4.5mm Diameter, 30mm length spring (https://www.amazon.com/dp/B09NQGR6QG)
- 1 - .3 x 4 x 15mm 9 lap compression spring (https://www.amazon.com/dp/B0BVTDP29W)
- Jollylook Instant Mini Film Development Unit (https://jollylook.com/products/jollylook-instax-mini-film-development-unit)
- 1 - 100mm focal length, 40mm Diameter, 6mm height lens (https://www.amazon.com/dp/B0C3B8DSBX)
- 4 - M3 x 30 screws, 1 - M3 x 8 screws, 2 - M2 x 20 screws, and 2 - M2 x 8 screws
- 1 - 120 degree, 4.5mm Diameter, 30mm length spring (https://www.amazon.com/dp/B09NQGR6QG)
- 1 - .3 x 4 x 15mm 9 lap compression spring (https://www.amazon.com/dp/B0BVTDP29W)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
