Thingiverse
Jar Tilter
von Steamboat_Ed
2
Downloads
2
Likes
0
Makes
This is the THIRD TIME I've uploaded this; let's see if Thingiverse can get it's shit together this time.
Put a mostly empty honey jar in this, wait an hour or two and all the good goo will be in one 'corner'. Makes it easier to scoop out the last little bit.
The opening is 80mm for a 3 in. diameter jar. Scale it up for a bigger jar.
2021_08_25:
-Just uploaded Jar_Tilter_06B which has fewer sharp edges. It should be easier to remove scaffolding from this one too.
Put a mostly empty honey jar in this, wait an hour or two and all the good goo will be in one 'corner'. Makes it easier to scoop out the last little bit.
The opening is 80mm for a 3 in. diameter jar. Scale it up for a bigger jar.
2021_08_25:
-Just uploaded Jar_Tilter_06B which has fewer sharp edges. It should be easier to remove scaffolding from this one too.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
