Thingiverse
Jar with Spoon
door Liviebo
2
Downloads
2
Likes
0
Makes
This is modeled after a small jar with a cork lid I use for fish food. Since I didn't want to go out of my way to buy one and couldn't find a file for it, I made one.
The spoon has two sizes of scoops, one for large amounts one for small. The lid just sits on top of the jar and doesn't seal. Sorry the previews are sideways I'm bad with orientation between file types. You will need supports for the jar portion so the holder portion prints correctly. The spoon and lid don't need supports.
The first jar was printed on my Ender 3 in just under 8 hours at .2 mm layer height and 60 mm/sec. The black and clear jar was printed on my CR-10 V3 at .2 mm layer height and 100 mm/sec this one took almost 6 hours. For this one I used some generic black PLA until the lid was finished, then switched the filament to Protopasta Translucent Iridescent Ice HTPLA. I did not print either of these with supports to see how they would turn out. aside from some stringing I had to clean up, they still lo
The spoon has two sizes of scoops, one for large amounts one for small. The lid just sits on top of the jar and doesn't seal. Sorry the previews are sideways I'm bad with orientation between file types. You will need supports for the jar portion so the holder portion prints correctly. The spoon and lid don't need supports.
The first jar was printed on my Ender 3 in just under 8 hours at .2 mm layer height and 60 mm/sec. The black and clear jar was printed on my CR-10 V3 at .2 mm layer height and 100 mm/sec this one took almost 6 hours. For this one I used some generic black PLA until the lid was finished, then switched the filament to Protopasta Translucent Iridescent Ice HTPLA. I did not print either of these with supports to see how they would turn out. aside from some stringing I had to clean up, they still lo
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
