Jato Conversion

This is a Jato Conversion with my spin on it. I have always loved the Jato. Just don't care for Nitro anymore. I used https://www.thingiverse.com/thing:1581048 motor mount. And design the rest. All you need to complete this build a few extra 3mm screws and 2-20mm standoffs and a slash battery stap TRA7426.

Everything screws together in the stock holes. I was able to reuse the jato RX lid. you will have to trim 2mm off the lip that hold it do to the stand off.

I printed will 3mm top/bottom/side walls that way all screw holes were strong.

print with support

base 50% infill
Servo 100% infill
Battery 50% infill
motor mount 100% infill ABS