Jawhorse wall mount

Summary A convenient way to store your Rockwell Jawhorse out of the way. Mounts to the wall with five #10 screws. I would recommend printing with a very high infill, I used 55% and it's had no signs of failure yet. To enable the Jawhorse to be wall mounted requires removing the plastic roller on the bottom of the clamp, instructions are provided below. Will not work with the RK9002 Sheetmaster model. Jawhorse Alterations Removal of the roller is very simple and only requires a phillips screwdriver. Step One: Remove screws circled in red, loosen both screws circled in green. After this is done the front cover printed with the word "JAWHORSE" should pull straight out. Step Two: Remove both screws circled in green, loosen one screw circled in blue and remove the other screw circled in blue. This will allow the roller to pivot out. After the roller has been pivoted it out you can slide it off its axle. Step Three: Pivot the axle back into place and put the screws back in revers order. Your