Jaws Board Game Insert

This is an organizer I made for the board game: Jaws, as there didn't appear to be a free one on Thingiverse. It is designed to allow the box to be stored in any orientation, while keeping the pieces in place.

You'll need to print two of both the card holders and the TopFiller pieces. Supports were needed for the card holders (to allow for the overhang around the nesting section at the bottom of the holder to print properly), but no other parts required supports.

I printed in low detail (.32 layer height) and low infill (10%) and everything came out fine.

I've included my Fusion 360 file if anyone wishes to make improvements or remixes.