Thingiverse
Jawz
door stxal
31
Downloads
51
Likes
0
Makes
. "Jawz" is a clamping tool that screws onto the end of a threaded broom stick and is designed to grip various thicknesses of sponges, steel wool or scotch brite abrasive pads, etc.
This thing is "print-in-place" with the axle oriented vertically. Support material is required. My first few prints have an infill of 20% which seems sufficient.... time will tell. The jawz are tensioned by means of a 50mm M5 hex head bolt and corresponding washer and wingnut resulting in a gripping thickness from zero to about 32mm.
A couple of notes: 1. This thing has not been extensively field tested and will be iterated upon as necessary, and 2. Threaded broomsticks probably come in a variety of thicknesses and thread pitches. I include a measured photo of the male thread I modeled from.
As usual with print-in-place items, mobilizing the joint can be a bit tricky. Take your time. I'd also suggest removing any support material not absolutely required prior to printing. This design does require
This thing is "print-in-place" with the axle oriented vertically. Support material is required. My first few prints have an infill of 20% which seems sufficient.... time will tell. The jawz are tensioned by means of a 50mm M5 hex head bolt and corresponding washer and wingnut resulting in a gripping thickness from zero to about 32mm.
A couple of notes: 1. This thing has not been extensively field tested and will be iterated upon as necessary, and 2. Threaded broomsticks probably come in a variety of thicknesses and thread pitches. I include a measured photo of the male thread I modeled from.
As usual with print-in-place items, mobilizing the joint can be a bit tricky. Take your time. I'd also suggest removing any support material not absolutely required prior to printing. This design does require
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
