MakerWorld
Music
Go to Model
JBL Wave Buds Case
235
Downloads
48
Likes
123
Makes
Created this case because my JBL Wave Buds came without a cover or ear tips—super annoying. So I designed a clean, support-free print that’s easy to make and works great. Here's what you get:✅ Features:Perfect fit – snug and secure for JBL Wave BudsNo screws – held together with just 4 magnets (ø3x2mm)Durable hinge – uses a piece of filament instead of snap jointsNo rattle – lid stays closed tight with proper magnet alignmentEasy charging – port hole fits all standard USB cablesExpress your self – fully supports coloring in Bambu Studio with AMSSupport-free – no hassle with pesky supports🛠️ Assembly Tips:Insert the Lid: Align the hinge holes and push in a ~6 cm piece of 1.75 mm filament. Use pliers if it’s tight. If needed, pull both ends to slightly compress the filament and make it easier to slide in.Install Case Magnets: Press 2 magnets (3x2 mm) into the holes on the case body using pliers—watch out, they’re small and slippery.Align Magnet Polarity: Snap the other 2 magnets ont
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!