Thingiverse
Jenga Sleeve
von muchtall
52
Downloads
34
Likes
0
Makes
A sleeve meant to enclose the Jenga block holder/aligner device here: https://www.thingiverse.com/thing:826036
Basically a remix of https://www.thingiverse.com/thing:1952372, which had walls that were too thin and therefore not durable enough. This doubles the wall thickness from 0.8 mm to 1.6 mm.
The font used for the Jenga label is just from the basic fonts in Tinkercad. Feel free to modify if know of a better font to put on there...
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/czCiw7e7OOz
Basically a remix of https://www.thingiverse.com/thing:1952372, which had walls that were too thin and therefore not durable enough. This doubles the wall thickness from 0.8 mm to 1.6 mm.
The font used for the Jenga label is just from the basic fonts in Tinkercad. Feel free to modify if know of a better font to put on there...
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/czCiw7e7OOz
muchtall veröffentlicht auch auf
36 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!