Thingiverse
Jericho
von Scarypoppins
17
Downloads
15
Likes
0
Makes
40mm Cooling fan to fit Anet A2.
Got tired of not being able to see the print progress because of massive shrouds blocking the view and hanging out from the print head, not to mention the extra forces being put on the x carriage due to the way alot of the coolers hang out.
You may have to set your fan to 60-70% as it does have a high flow
Printed without supports at 0.2 and 20% 70mms
Got tired of not being able to see the print progress because of massive shrouds blocking the view and hanging out from the print head, not to mention the extra forces being put on the x carriage due to the way alot of the coolers hang out.
You may have to set your fan to 60-70% as it does have a high flow
Printed without supports at 0.2 and 20% 70mms
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
