Jetpack Flame - Mandalorian

I looked everywhere for a realistic jetpack flame for my Mandalorian costume. I could not find anything I liked. I did find a great flame model made for a wall lamp made by DeltaPlus. So I went about modifying it to fit my jetpack funnel.
• I stretched the flame to make it look more like a thruster flame
• I added a short pipe leading to an inner cone shaped flame (from BatPenry) so it looked more dynamic and less single layered
• I connected the 2 flame shells at the base with a thin disk open in the middle so that inner cone gets the most light from the source
• I added an outer section shaped like a cone to fit snugly into the thrusted cone for gluing
• I printed using transparent orange PLA filiment
• I took apart a $10 flashlight that has good brightness to use as the light source
I included some additional pics:
• My finished jetpack lit up.
• An early prototype lit by flashlight is not the right dimensions, demonstrating how the flashlight works and you can see the effect with