Thingiverse
JGAurora A5 leveling knob
von lazax
69
Downloads
48
Likes
1
Makes
Bed leveling knob for JGAurora A5 (A3). Slightly bulkier than the factory one, still fits into the small space. Much easier to use.
You will need 4 pieces of M3 female/female hex (10 mm long) spacers, which can be inserted heated up to 150-200°C. I could only buy a 30 mm long one which was trimmed down to 10 mm with a handsaw.
Make sure the knob isn't taller than 12.2 mm, otherwise it might bump into the outlets on the right side.
You will need 4 pieces of M3 female/female hex (10 mm long) spacers, which can be inserted heated up to 150-200°C. I could only buy a 30 mm long one which was trimmed down to 10 mm with a handsaw.
Make sure the knob isn't taller than 12.2 mm, otherwise it might bump into the outlets on the right side.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
