Thingiverse
JGMaker Magic Improved Part Cooling Duct
door DaHai8
38
Downloads
24
Likes
1
Makes
This is a Slightly improved Part Cooling Duct for the JGMaker (JGAurora) Magic 3D Printer.
Basic improvements over the stock duct include:
+ 3mm separation from the heater block so its doesn't melt like the original
+ air flow directed better to the part below the nozzle tip instead of over to the side
+ vent now centered across nozzle tip instead of mainly in the front
+ can be replaced *fairly* easily without disassembling the print head
See 'Print Settings' below for printing suggestions.
Basic improvements over the stock duct include:
+ 3mm separation from the heater block so its doesn't melt like the original
+ air flow directed better to the part below the nozzle tip instead of over to the side
+ vent now centered across nozzle tip instead of mainly in the front
+ can be replaced *fairly* easily without disassembling the print head
See 'Print Settings' below for printing suggestions.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
