Thingiverse
Jigsaw Paint Shaker
von pyaniz
105
Downloads
61
Likes
2
Makes
Structure for a Jigsaw bottle Shaker (I got a very cheap one ~16 U$S)
What you need:
-------------
- Filament, preferably PETg
- A Jigsaw (I got [this one](https://www.walmart.com/ip/Hyper-Tough-3-5-Amp-Jig-Saw-JS55G1B/199349530))
- 7 M3 screws (6mm long should sufice, you may want an 8mm for the center one.
- 7 M3 Nuts
What to do:
----------------
- Print all parts (You'd likely want to print on PETG as it will probably last longer)
- [!] Insert a nut NOW on the Part B before mounting on the blade.
- Dismount the Blade from the saw (and unplug the saw to do this)
- The 'Blade_covers' go around the blade, it should fit any standard 3 mm thick blade.
- Tighten all 6 the screws (Don't go crazy, it's plastic) Leave the center screw for the end.
- Tighten the center screw a bit until you can't remove the blade with your hands (Don't break the blade)
Future Updates
---------------------
- Extend the lid a bit so it holds the bottle in place.
- Will Add a cap spec
What you need:
-------------
- Filament, preferably PETg
- A Jigsaw (I got [this one](https://www.walmart.com/ip/Hyper-Tough-3-5-Amp-Jig-Saw-JS55G1B/199349530))
- 7 M3 screws (6mm long should sufice, you may want an 8mm for the center one.
- 7 M3 Nuts
What to do:
----------------
- Print all parts (You'd likely want to print on PETG as it will probably last longer)
- [!] Insert a nut NOW on the Part B before mounting on the blade.
- Dismount the Blade from the saw (and unplug the saw to do this)
- The 'Blade_covers' go around the blade, it should fit any standard 3 mm thick blade.
- Tighten all 6 the screws (Don't go crazy, it's plastic) Leave the center screw for the end.
- Tighten the center screw a bit until you can't remove the blade with your hands (Don't break the blade)
Future Updates
---------------------
- Extend the lid a bit so it holds the bottle in place.
- Will Add a cap spec
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!