Thingiverse
JK BMS Power-Button holder
door GunterG
1
Downloads
2
Likes
0
Makes
This button holder mounts the JKBMS Powerbutton to a 20mm wooden plate.
* I have two banks so I created refined variants with numbers on it,
* plus my BMS is on the other, opponent side, so for the optics I added a small cable tunnel. It also fixes the cable in place.
* The outer gap might be useful, if the button is already hard wired.
dimension:
* plate thickness 20mm
* button/hole diameter 11.8mm
* with 13.8mm button rim
* I have two banks so I created refined variants with numbers on it,
* plus my BMS is on the other, opponent side, so for the optics I added a small cable tunnel. It also fixes the cable in place.
* The outer gap might be useful, if the button is already hard wired.
dimension:
* plate thickness 20mm
* button/hole diameter 11.8mm
* with 13.8mm button rim
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
