JLab Earbuds Case

I got tired of the magnets in my JLab earbud case setting the buds loose in my pocket so I made a cover for it!

I recommend printing in the orientation shown in the pictures as this aligns the print lines along the length of the tab and prevents breaking.

Once you get rid of the supports, you might need to clean a bit more off the back of the lip on the tabs. I carefully used a knife to keep it good and flat, but an emery board/nail file might also work well. Clean there and on the rear brackets until you get a nice snappy fit.

Then just round any sharp corners, sand to your liking, and enjoy!
No more picking pocket debris out of my ears!