JMI Wheeley Level Adjuster

It's just a simple print of a device to use on my drill to raise and lower my tripod dolly. This works with the leveling screw handles of the JMI Wheeley Bars. I purchased the leveling screws to use on my homemade tripod dolly. I used a 3/8" coarse bolt about 6" in length and just chuck the threaded end in my drill.

Print upside down and depending on your printer you might need supports for the top bevel

Printed in PETG or any reasonable strong material. I used PLA and it works well enough.
I did add some wall for strength and used Gyroid infill at 25%. Probably overkill.

Printed on a CR6-SE