MakerWorld
Other House Models
Zum Modell
John Lennon Coaster
65
Downloads
36
Likes
40
Makes
Quick 1 hour print of a John Lennon coaster! After printing, I realise that the layer of Grey is probably not necessary, but you can use it if you wish! If you decide to forgo the grey, replace it with white. Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm Filaments Used: - PLA Siddament Black Transmission Distance: 0.2 - PLA+ eSun Grey Transmission Distance: 1.4 - PLA META Sunlu White Transmission Distance: 9.6 Swap Instructions: - Start with Black - At layer #20 (0.92mm) swap to Grey - At layer #32 (1.4mm) swap to White for the rest.
cyanidesugar veröffentlicht auch auf
113 zusätzliche Modelle auf 3 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!