John's Pot 1.0

I designed this pot to be printable in one piece without any supports while still providing drainage. It should also be resizeable to a good range. I've tried 50% (for seedlings) and 110% for a relatively small houseplant.

The pot prints best with the classic 0.4mm nozzle, but 1.0mm also works well for printing larger versions faster. Depending on the size and nozzle, it will need at least 20% infill to properly support the curve around the drainage hole.

I hope you find this model as useful as I did! Feel free to reach out if you'd like to see any improvements to the design :)