Thingiverse
Joint case
von joda6876
20
Downloads
15
Likes
1
Makes
Simple Joint case designed by me.
Smellproof and mostly waterproof.
Print the cone part upside down (opening facing down) and use a brim or raft.
Otherwise it will fall over while printing.
The cap can be printed without extra built plate adhesion.
On 0.25res and 20%infill it should take about~
Cone: 1:25h
Cap: 12min
The cone is also wide enough to house big activ filters
Smellproof and mostly waterproof.
Print the cone part upside down (opening facing down) and use a brim or raft.
Otherwise it will fall over while printing.
The cap can be printed without extra built plate adhesion.
On 0.25res and 20%infill it should take about~
Cone: 1:25h
Cap: 12min
The cone is also wide enough to house big activ filters
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
