Jointer/Planer Blade Sharpening Jig
von thegraindoctor
204
Downloads
101
Likes
2
Makes
v1 of a jig used to hold my 12" jointer blades at a 45 degree angle for sharpening on a granite plate with wet/dry sandpaper.
This is a long print - took about 36 hours for me. The jig in the pictures is in two pieces because I had a Y axis layer shift about two thirds of the way up. It was less than a mm, but enough to mess with the registration of the jig with the blades. Rather than re-print, I cut at the shift line and use the jig in two pieces.
This is a long print - took about 36 hours for me. The jig in the pictures is in two pieces because I had a Y axis layer shift about two thirds of the way up. It was less than a mm, but enough to mess with the registration of the jig with the blades. Rather than re-print, I cut at the shift line and use the jig in two pieces.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
