Slicer Discord
Jonsbo N3 Backplane 10" rack mount – Modelo 3D imprimible de MakerWorld MakerWorld
Electronics

Jonsbo N3 Backplane 10" rack mount

11 Descargas
21 Likes
1 Makes
Ver Modelo
Jonsbo N3 Backplane Rack MountThis model is designed to mount the Jonsbo N3 Backplane within a 10-inch rack, providing a secure and space-efficient solution for NAS (Network Attached Storage) system builds. The bracket allows for clean integration of the backplane into a custom rack-mounted NAS chassis or enclosure.Hardware Requirements:3 × M4×16 mm screws and matching nuts/boltsRecommended Print Parameters:Material: PETG (for enhanced strength, flexibility, and temperature resistance)Perimeters/Walls: 4Top Layers: 6Bottom Layers: 6Infill: 20–30% (adjust as needed for rigidity)Note that holes are not cut all the way though in the print, after running tests with threads i found that leaving them closed and drilling a small pilot hole into the holes and putting the m4 screws in was much better. This results in a tight fit and less vibrations coming from anything else in your rack. PETG is recommended to ensure dimensional stability under load and during extended operation in warm environ
Categoría
Electronics
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA, PETG
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

CypherTheNet también publica en

4 modelos adicionales en 2 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección