Slicer Discord
JoshBot – 3D-Druckmodell von Thingiverse Thingiverse

JoshBot

32 Downloads
29 Likes
0 Makes
Zum Modell

Hello. I want to introduce you my work called JoshBot. This bot based on the Arduino Uno and controlled via Bluetooth. Built-in battery Li-po 1000 mah 2s is enough for 2.5 hours of continuous operation. Engines are hacked SG90. They work on L293 shield from Adafruit. On the front of the bot is an ultrasonic sensor which allows to avoid obstacles in Autonomous mode.
http://www.instructables.com/id/JoshBot/http://www.instructables.com/id/JoshBot/
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Ca. Druckzeit
2.5 h
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen