Joy-Con Wall mount

Custom Joy-Con Wall mount
=====================

This is my custom modeled Joy-Con Wall Mount. Designed in Fusion360 with a little trial and error.

It's designed only for the controllers to face each other inwardly, sadly the bottom trigger/bumper button sticks out further than the control stick.

Personally I mounted it with a good bit of double sided tape which works fine for such light controllers. Just don't try to rip it off the wall.

You may need to adjust your slicer settings, most likely changing Layer Height, and wall floor and ceiling options to ensure strength and a proper fit.

Resin printing this design could be ideal since it's small and I think it'd look neat printed in a clear resin without drainage holes or anything.

You can print it vertically without supports but the print is so tall relative to its other dimensions that I'd advise a good brim at minimum to ensure adhesion, otherwise print it on its back, use a little support with some blockers t