Thingiverse
JoyCon Caps (XB1 inspired)
von CoolTrainerDerek
24
Downloads
30
Likes
1
Makes
Print in TPU, I did mine @ .15 layer height no support. Pull/ cut out any sagging tpu from the inside before fitting.
They are made to go over the oem rubber grips, snug fit, but can be removed without pulling off the oem grip.
They have a close feel to the xbox one thumb sticks. the tall ones feel good but makes it hard to press B, the short ones are my favorite.
Let me know if this helps you!
They are made to go over the oem rubber grips, snug fit, but can be removed without pulling off the oem grip.
They have a close feel to the xbox one thumb sticks. the tall ones feel good but makes it hard to press B, the short ones are my favorite.
Let me know if this helps you!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!