Thingiverse
JoyCon Style Joystick - Mini Version
von nelsonii
6
Downloads
3
Likes
0
Makes
This is the original version of the joycon-sticked controller.
If using the STL, flip the _TOP Y 180 degrees in your slicer (so flat side is down).
No supports or rafts required. Take about 30 mins a piece on my Prusa.
Uses a replacement "joycon" style joystick and an Arduino Pro Micro / Leo. The hardest part is the breakout board between the joystick and the Arduino.
See my github for more info (github.com/nelsonii)
If using the STL, flip the _TOP Y 180 degrees in your slicer (so flat side is down).
No supports or rafts required. Take about 30 mins a piece on my Prusa.
Uses a replacement "joycon" style joystick and an Arduino Pro Micro / Leo. The hardest part is the breakout board between the joystick and the Arduino.
See my github for more info (github.com/nelsonii)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!