Thingiverse
Joystick Enclosure
door rglissmann
111
Downloads
81
Likes
0
Makes
This is an enclosure for a R/C joystick. I purchased the joystick board from Amazon. It was intended to be a Arduino shield but I removed the header connectors and will solder wires to connect to a Arduino Nano board. The Nano transmits the joystick X and Y positions and button pushes over bluetooth.
The enclosure clamshell was designed using OpenSCAD and can be customized. The bottom piece holds the Nano and bluetooth modules, a 9v battery and a power switch. The top piece has four tabs to secure the joystick board. The top and bottom pieces have a latch to hold them together. A small cutout allows inserting a screwdriver so it can be pried apart for service or replacing the battery.
The enclosure clamshell was designed using OpenSCAD and can be customized. The bottom piece holds the Nano and bluetooth modules, a 9v battery and a power switch. The top piece has four tabs to secure the joystick board. The top and bottom pieces have a latch to hold them together. A small cutout allows inserting a screwdriver so it can be pried apart for service or replacing the battery.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!